DAPZOI
Home Topics Quiz Login


Feedback Compensation MCQ Questions & Answers

Feedback Compensation MCQs : This section focuses on the "Feedback Compensation". These Multiple Choice Questions (MCQs) should be practiced to improve the Feedback Compensation skills required for various interviews (campus interview, walk-in interview, company interview), placement, entrance exam and other competitive examinations.




Question 1

As compared to the closed loop system, an open loop system is

A. More stable but less accurate
B. Less stable as well as less accurate
C. More stable as well as more accurate
D. Less stable but more accurate

View Answer

Question 2

Feedback control system is basically

A. High pass filter
B. Low pass filter
C. Band pass filter
D. Band stop filter

View Answer

Question 3

In control system excessive bandwidth is not employed because

A. Noise is proportional to bandwidth
B. It leads to low relative stability
C. It leads to slower time response
D. Noise is proportional to the square of the bandwidth

View Answer

Question 4

Insertion of negative feedback in control system affects:

A. The transient response to vanish uniformly
B. The transient response to decay very fast
C. No change in transient response
D. The transient response decays at slow rate

View Answer

Question 5

Open loop system is ___________ stable than closed loop system

A. More
B. Less
C. Inclined
D. Exponential

View Answer

Question 6

Primary purpose of using Feedback is :

A. To reduce the sensitivity of the system to parameter variations.
B. To increase the bandwidth of the system
C. To reduce the noise and distortion of the system
D. To increase stability of the system

View Answer

Question 7

Which of the following are the not characteristics of the closed loop systems?

A. It does not compensate for disturbance
B. It reduces the sensitivity of plant-parameter variations
C. It does not involve output measurements
D. It does not has the ability to control the system transient response

View Answer

Question 8

Which of the following will not decrease as a result of introduction of negative feedback?

A. Instability
B. Bandwidth
C. Overall gain
D. Distortion

View Answer

Question 9

Which of the statement is correct with regard to the bandwidth of the control loop system:

A. In systems where the low frequency magnitude in 0 dB on the bode diagram, the bandwidth is measured at the -3 dB frequency
B. The bandwidth is the measurement of the accuracy of the closed loop system
C. The stability is proportional to the bandwidth
D. The system with larger bandwidth provides slower step response and lower fidelity ramp response

View Answer

Question 10

Which one of the following effect in the system is not caused by negative feedback?

A. Reduction in gain
B. Increased in bandwidth
C. Increase in distortion
D. Reduction in output impedance

View Answer