Forced Feed System MCQs : This section focuses on the "Forced Feed System". These Multiple Choice Questions (MCQs) should be practiced to improve the Forced Feed System skills required for various interviews (campus interview, walk-in interview, company interview), placement, entrance exam and other competitive examinations.
Question 1
Forced feed lubricating system is found suitable in ___________
A. Low speed engines
B. High speed engines
C. Forced feed engines
D. Pressure feed engines
Question 2
In force feed system of lubrication, the valve stem is lubricated through ___________
A. Camshaft hole
B. Rocker arm shaft
C. Crankshaft hole
D. Small pipe
Question 3
In forced feed system of lubrication, the connecting rod bearings are lubricated through the ___________drilled holes in
A. Crank shaft
B. Cam shaft
C. Connecting rod
D. Crank case
Question 4
In forced feed system of lubrication, the oil pressure should be almost ___________
A. 30 kg/cm2
B. 20 kg/cm2
C. 10 kg/cm2
D. 3 kg/cm2
Question 5
In forced feed system of lubrication, the piston pins are lubricated by means of hole drilled in ___________
A. Connecting rod
B. Cam shaft
C. Crank shaft
D. Crank case
Question 6
In forced feed system of lubrication, the type of filter used ___________
A. By pass filter
B. Strainer filter
C. Screen filter
D. Half flow types
Question 7
In forces feed system of lubrication the pump is driven by ___________
A. Electric motor
B. 12 V battery
C. Cam shaft
D. Flywheel
Question 8
Lubrication is needed in engines because of ___________
A. Viscosity
B. High temperature
C. Friction
D. Higher draft
Question 9
The pump used in forced feed system of lubrication is ___________
A. Reciprocating pump
B. Centrifugal pump
C. Positive displacement pump
D. Negative displacement pump
Question 10
Use of very thin lubricating oil in lubrication system causes ___________
A. Low of pressure
B. Less engine speeds
C. Higher fuel consumption
D. High thermal efficiency