Paper - Press Selection MCQs : This section focuses on the "Paper - Press Selection". These Multiple Choice Questions (MCQs) should be practiced to improve the Paper - Press Selection skills required for various interviews (campus interview, walk-in interview, company interview), placement, entrance exam and other competitive examinations.
Question 1
_________ in the first press because of the large amount of water being removed. This avoids sheet crushing and allows more water to be removed.
A. Double felts
B. Triple felts
C. Single felts
D. Quadruple felts
Question 2
A _________ is a pair of squeeze or wringer rolls designed to remove water mechanically and smooth and compress the sheet.
A. Push
B. Press
C. Pull
D. Stress
Question 3
A _________ roll press uses helical grooves cut into the bottom press roll that is in contact with the pressure felt. These _________ provide additional volume and a path for water transfer from the sheet through the press nip.
A. Shoe
B. Felt
C. Groove
D. Kennedy
Question 4
A design that gives the ability to have high machine speeds with operation stability and low vibration. This process comes under which category?
A. Flocculation
B. Deflocculation
C. Alum
D. Press
Question 5
A reverse press is mounted in a way that the paper web goes through in a direction that’s opposite to its original travel direction so that both sides on the web, therefore providing smoothing action on the opposite side of the paper web. This can also be accomplished by using _________ smooth press rolls.
A. One
B. Two
C. Three
D. Four
Question 6
Allowing both sides of the web to be pressed against a solid roll at different times. This process comes under which category?
A. Flocculation
B. Deflocculation
C. Alum
D. Press
Question 7
In a _________ 2 smooth rolls are utilized and the capacity to remove water depends on the void volume of the press felt(s) to receive the water.
A. Smooth press
B. Tilted press
C. Plain press
D. Triangular press
Question 8
Shoe presses or other special presses to promote good fiber bonding and decrement in web moisture contents.
A. TRUE
B. FALSE
Question 9
The press felt normally runs over the paper web going through a press section. It’s designed to adsorb H2O squeezed out of the sheet and to support the sheet throughout the presses.
A. TRUE
B. FALSE
Question 10
The use of a pickup felt while the web is still in contact with the forming material so that there is no unsupported web during the transfer. An open draw is delayed until several press nips have been passed. An unsupported web is called _________
A. Closed draw
B. Open draw
C. Empty draw
D. Linkage draw