Power Shaft MCQs : This section focuses on the "Power Shaft". These Multiple Choice Questions (MCQs) should be practiced to improve the Power Shaft skills required for various interviews (campus interview, walk-in interview, company interview), placement, entrance exam and other competitive examinations.
Question 1
______ openings or indentations of corrugations in plaster.
A. Helms
B. Grains
C. Keys
D. Flake
Question 2
________ is a process of mixing various constituents of plaster.
A. Grazing
B. Blistering
C. Gauging
D. Hacking
Question 3
_________ is used to check the level of plastered surface.
A. Gauging trowel
B. Plumb bob
C. Floating Rule
D. Float
Question 4
__________ mm thick plastering is done for stone masonry.
A. 10 mm
B. 15 mm
C. 18 mm
D. 20 mm
Question 5
Calculate the power transmitted in the shaft at 150 rpm. Take torque as 9000Nm.
A. 140 kW
B. 150 kW
C. 160 kW
D. 175 kW
Question 6
Skimming float is ____________
A. Wooden float
B. Metalled float
C. Tempered steel float
D. Asbestos cement sheet
Question 7
Stucco is a type of _________
A. Varnishing
B. Distempering
C. Plastering
D. Whitewashing
Question 8
The small projections of plaster are known as ________
A. Back
B. Dado
C. Dot
D. Hack
Question 9
The thickness of cement plaster should not be more than _______
A. 15 mm
B. 12 mm
C. 16 mm
D. 20 mm
Question 10
The thickness of lime plaster varies from _______ to ________ mm.
A. 15 - 20 mm
B. 12 - 15 mm
C. 18 - 25 mm
D. 20 - 25 mm
Question 11
Which of the following blasters contains pulverized alum?
A. Water proof plaster
B. Plaster on lathe
C. C plaster
D. Marble plaster
Question 12
Which of the following is a defect in plastering?
A. Flaking
B. Scrap
C. Rust
D. Staining
Question 13
Which of the following is known as laying trowel ?
A. Float
B. Gauge trowel
C. Floating Rule
D. Skimming float
Question 14
Which of the following is not a cross drainage work?
A. Aqueduct
B. Head regulator
C. Super passage
D. Level crossing
Question 15
Which of the following plastering is widely adopted in rural areas?
A. Stucco Plastering
B. Mud plastering
C. Lime plastering
D. Asphalt plastering
Question 16
The thickness of lime plaster varies from _______ to ________ mm.
A. 15 – 20 mm
B. 12 – 15 mm
C. 18 – 25 mm
D. 20 – 25 mm
Question 17
Which of the following is known as” laying trowel”?
A. Float
B. Gauge trowel
C. Floating Rule
D. Skimming float