Starting System Testing MCQs : This section focuses on the "Starting System Testing". These Multiple Choice Questions (MCQs) should be practiced to improve the Starting System Testing skills required for various interviews (campus interview, walk-in interview, company interview), placement, entrance exam and other competitive examinations.
Question 1
Continuity in the field windings can be tested in which device?
A. Voltmeter
B. Multimeter
C. Galvanometer
D. Ammeter
Question 2
How is the drive system between the engine and gearbox in modern starter motor?
A. Shaft drive
B. Belt drive
C. Belt drive or connected directly to the flywheel
D. Connected directly to the flywheel
Question 3
If there is a wear or damage is more than the permissible limits, what has to be done?
A. Replace the brushes
B. Grind the brushes
C. Skim the brushes
D. Mill the brushes
Question 4
In modern starters, the pole shoes are replaced with which component?
A. Titanium coil
B. Carbon brushes
C. Permanent magnet
D. Electro-magnet
Question 5
In the case of shift, it must be noted that the test should not be continued for more than how many seconds?
A. 31-40min
B. 5-7sec
C. 30-55min
D. 10-15seconds
Question 6
Lights dim but slightly, what does this indicate concerning Starter motor?
A. Weak battery
B. Loose connection
C. Open circuit in the field winding
D. Defective starter motor
Question 7
Lights get dim heavily, what does this indicate concerning Starter motor?
A. Weak battery
B. Loose connection
C. Open circuit in the field winding
D. Defective starter motor
Question 8
Lights go off completely, what does this indicate concerning Starter motor?
A. Low battery power
B. Loose connection
C. Open circuit in the field winding
D. Defective starter motor
Question 9
Lights remain unaffected, what does this indicate concerning Starter motor?
A. Weak battery
B. Loose connection
C. Open circuit in the field winding
D. Defective starter motor
Question 10
What is the minimum cranking speed for a C.I engine without glow-plugs?
A. 150-180rpm
B. 60 to 140rpm
C. 60-90rpm
D. 100-200rpm
Question 11
Which device is used to check the current?
A. Ammeter
B. Voltmeter
C. Galvanometer
D. Odometer
Question 12
Which device is used to check the voltage?
A. Ammeter
B. Voltmeter
C. Galvanometer
D. Odometer